Baumatic BYDI630 - Modifying Wash Programs; Changing Wash Program; Adding More Dishes During Cycle; End of Wash Cycle

23
Changing the wash program
IMPORTANT: This should only be attempted when the cycle has
only just started, otherwise the detergent tablet may have
already released or you could have hot water escaping.
o Slightly open the door of the appliance to stop the current cycle.
o Press and hold down the program selection button (4) for 3
seconds to cancel the wash program. Then use the program
selection button (4) to choose the correct wash program.
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
Adding more dishes
IMPORTANT: Additional items can be added to the wash load if
the cycle has only just started, otherwise the detergent tablet
may have already released or you could have hot water
escaping.
o Slightly open the door of the appliance to stop the current cycle.
o When the spray arms have stopped operating you can open the
door completely.
o Introduce the additional items into the appliance and close the
door.
o After a few seconds, you will hear the appliance continue with
the washing cycle.
At the end of a wash program
o A buzzer will sound for 8 seconds and then stop.
o Open the door of the appliance.
o Use the ON/OFF button (1) to switch the dishwasher off and
unload the contents.
IMPORTANT: Wait for a few minutes before unloading the
dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will
also dry better.