Installing the oven into a housing unit
o Push the oven completely into the aperture of the housing unit
and then centre it.
o Open the door of the oven and then screw through the 4 holes
shown above, into the housing unit. IMPORTANT: These
screws MUST be fully tightened.
o Follow the electrical connection information on page 45 and then
check that the appliance is functioning correctly.
Troubleshooting
o The microwave will not switch on.
* Check that the appliance has been connected to the mains
supply correctly.
* Check that the fuse in the moulded plug has not blown.
* Check that the fuses in your fuse box have not blown.
* If fuses blow on a regular basis, then we would recommend that
you consult with a qualified electrician.
* Check that there has not been a power cut.
o The microwave will not start cooking.
* Check that the door is properly shut.
* Check that the door seal and surrounding area are clean.
* Check that you have programmed the oven correctly.
48
To Next Page
Loading...
