Baumuller BUM 60 - Drilling Patterns

Preparing for mounting
Instruction handbook BUM 60 / BUS 60
Document No.: 5.01032.05 Baumüller Nürnberg GmbH
40
of 82
6.2
6.2.1 Drilling patterns
Use the drilling pattern to make the necessary drill holes/cutout sections.
NOTE!
Consider the minimum clearances for cooling when making the drill holes.
All dimensions in millimeters [mm].
page 26
Further notes see ZDimensions– on page 23 and ZEnvironmental requirements– on
.
How to determine the required space in the control cabinet, see ZDimensions– on page 23.
Tolerance
specifica-
tions
Drill hole dimensioning ±0.2 mm
Relative tolerance of discretionary divisions ±0.1 mm
Figure 6: Drilling pattern