43
of 82
Instruction handbook BUM 60 / BUS 60
Document No.: 5.01032.05
7INSTALLATION
In this chapter we describe the electric installation of the device. The mechanical installation is
described in
ZMounting– on page 37.
Before installing assure, that the technical preconditions are fulfilled:
1 Check the requirements to the electrical power supply and check if the existing power supply
is suitable.
2 Check the requirements to the electrical cables and provide the according cables.
3 Check the characteristics of the connections and configure the connections accordingly.
7.1 Safety instructions
NOTE!
Installation shall only be performed by employees of the manufacturer or by other
qualified personnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re
-
sponsible for the safety of the facilities to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m Occupational training or instruction, and the authorization to commission, ground
and mark electrical power circuits and devices in accordance with the standards of
the safety engineering.
m Occupational training or instruction, in accordance with the standards of work safe-
ty, for the care and use of appropriate safety equipment.
To Next Page
Loading...
