Function Prog.
no.
Level
1)
Standard value
Info Option
The display of the information values depends on the operation status!
Fault message
Servicing message
Setpoint manual control
Controller stop setpoint
Boiler temp
State heating circuit 1
State heating circuit 2
State heating circuit 3
State DHW
State boiler
State solar
State solid fuel boiler
State buffer storage tank
State swimming pool
Year
Date
Time
Telephone customer service
1)
Eu = End user; C = Commissioning; E = Engineer
Note: Parameters with the program numbers 1- 54 are individual parameters of
the operating unit and the room unit and may, therefore, be set differently on
both devices. All paramteres from programme number 500 onwards are stored on
the controller and, therefore, identical. The value changed last is the valid value.
8.4 Parameter list explained
In the following the individual parameter of the are explained.
Time and date
Time of day and date
(1 - 3)
The control has a year clock with setting possibilities for time, day, month and
year. Time and date must be correctly set, so that the heating programs can oper-
ate to previously carried out programming.
Summertime
(5 - 6)
The start of the summertime can be set under prog. no. 5; the end of summer
time will be set under prog. no. 6. The time changing will be carried out on the
Sunday following the set date.
Operator section
Language
(20)
The language of the menu guidance can be modified under prog. no. 20.
Info
(22)
Temporarily : The information display returns to the basic display after 8 minutes.
Permanently : The information display remains permanently displayed after call-
up with the information button.
Programming
39
To Next Page
Loading...
