baxter EASYSPRAY Reference Guide

EASYSPRAY and DUPLOSPRAY MIS Pressure Regulator -
Instructions for correct usage
EASYSPRAY Pressure Regulator Operation (open surgery)
1 Insert 9V battery into the
EASYSPRAY Pressure
Regulator device
4 Connect Spray Set filters
to EASYSPRAY device.
Connect the blue filter to the
blue female luer connector
and the clear filter to the
male luer connector
2 Connect EASYSPRAY device
to IV pole or cart rail using
the clamps on the back of
the device
5 Turn the on/off switch on the
front side of the EASYSPRAY
to the ON (I) position
3 Use suitable connection tube
to connect the EASYSPRAY
device to medical air
(ranging 3.5 – 7 bar /
50 – 100 psi)
6 Check the gauge on the
EASYSPRAY device for the
appropriate pressure range
of 1.5-2.0 bars
(21.5-28.5 psi). Adjust
pressure setting by turning
the black pressure control
knob
DUPLOSPRAY MIS Pressure Regulator Operation (laparoscopic procedures)
1 Position DUPLOSPRAY
System so the foot pedal is
placed next to the surgeon’s
foot at time of application
4 While depressing foot pedal,
adjust gas flow rate to
1.0-2.0 liters per minute.
Check gas flow by noting
height of ball in flow gauge
while stepping on foot pedal
2 Attach gas supply hose,
located at back of regulator,
to source of medical grade
CO
2
5 Depress foot pedal to start gas flow prior
to applying TISSEEL Fibrin Sealant. Check
gas flow gauge on regulator before inserting
applicator. If flow level ball does not move when
foot pedal is depressed, the applicator tip is
occluded and should be replaced
3 Attach spray set to regulator.
Connect the blue vent line
filter to the blue female luer
and the clear gas line
filter to the male luer on the
regulator

baxter EASYSPRAY Specifications

General

Brand	baxter
Model	EASYSPRAY
Category	Medical Equipment
Language	English