baxter OV310G Operation Manual

– 10 –
BUTTON ACTION DISPLAY
Press to open or close the vent
manually.
The indicator light next to the VENT button is lit when
the vent cycle is enabled.
Select the vent to be open during a recipe step by
enabling this during the edit mode.
This button can also be used to COOL DOWN the oven
while the door is open.
To use this feature, have set temperature at least 25°F
(14°C) cooler than the oven temperature then press the
VENT button.
This COOL DOWN mode is exited by pressing any
button or closing the door.
ON
OFF
POWER
TIMER
ON
OFF
AM
PM
AUTO
ON/OFF
TIMER
AUTO
ON
TIME
AUTO
OFF
TIME
AUTO
OFF
TIME
HEAT ON
OVEN
TEMP
SET
TEMP
ON
MINUTES
ON
ON
BAKE
TIMER
STEAM
TIMER
AIRFLOW
DELAY
START
STOP
STOP
MINUTES SET
SECONDS
MINUTES REMAINING
STEPS
PROGRAM
2
3
4
1
VENT
COOL
DOWN
COOL
DOWN
STEP
Use to cool down the oven. To enable this feature, set a temperature at least 25°F
(14°C) cooler than the oven temperature then press the
COOL DOWN button.
The COOL DOWN mode is exited when temperature
reaches 25°F (14°C) below set temperature when the
door is open, or when the temperature is below the set
temperature when the door is closed or by pressing any
button.
Opening or closing the door does not cause this COOL
DOWN mode to exit.
Auto ON/OFF Timer
Setting Clock
Auto ON/OFF Timer display shows the current time of day. To set the clock, the control must be turned on.
Press and hold either of the arrow buttons until the colon between the hours and minutes display stops
blinking. Use the up and down arrow buttons to adjust time of day. After 5 seconds of no use, the colon
will start to blink again.
The oven can be set to turn itself on and off. After the Auto ON/OFF Timer is set, the POWER ON OFF
button can be pressed to turn the oven off. This will not disrupt the AUTO ON/OFF setting. Electrical power
to the oven must remain on.
1. To set the oven to turn on, press and hold the AUTO ON TIME button. The previously entered start
time will appear in the display. Use the UP and DOWN arrows to adjust the start time. Then release
the AUTO ON TIME button.
2. To set the oven to turn off, press and hold the AUTO OFF TIME button. The previously entered end
time will appear in the display. Use the UP and DOWN arrows to adjust the end time. Then release
the AUTO ON TIME button.
3. To enable the automatic start, press the TIMER ON/OFF button until the indicator LED to the right
of the TIMER ON/OFF button is illuminated.
Backup Battery
The clock is backed up by a lithium battery, which keeps the clock circuitry operating when all external
power is off. If the battery becomes low or dead while the external power is off, the display will read 12:00
(12 hr mode) or 0:00 (24 hr mode) and will not increment until a new time is set. The clock will operate
with a dead or missing battery, but must be set each time external power is turned on. Batteries should
be replaced when low or dead to avoid corrosive damage to the circuitry.

baxter OV310G Specifications

General

Brand	baxter
Model	OV310G
Category	Oven
Language	English