23
ENUSER’S MANUAL DSC
Then press to confirm and back to the weighing and counting mode. When counting, suppose the quantity of the
product is between the upper and the lower limit, buzzer will buzz to alarm.
AUTO-AVERAGING OPERATION
1. Press and hold
before turning the scale on and turn ON the scale without empressing. Press repeatedly until
screen shows AVER. With
key , set the auto-averaging into “0” (“0” stands for allowing auto-averaging, “1”
stands for forbidding auto-averaging.) Press
repeatedly until return to main screen.
2. Put samples of the products on the scale for sampling. In the process of counting, if the additional quantity is less
than sampling quantity, the scale will auto-averaging with buzzing. Otherwise, the scale will terminate auto-averaging.
3. Only when sampling finished, can auto-averaging workable.
CALIBRATION
Press and hold
turn on the scale. TOTAL QUANTITY screen shows the single-point calibration information “CAL"
and the unit weight shows the weight needs calibration. If you need to change the calibrated weight value, you can
press the numeral key to input new calibrated weight value and display it in the unit weight screen. If you inout incor-
rectly, you can press
to clear it and input again. Put the corresponding weight and display it in the weight screen.
Load the weight on the pan after it’s steady, press
to confirm and back out from calibration mode.
UNIT SELECTION
Press de
for 5 seconds, then press to choose the desire unit such as g, kg, lb. Press the again back to the
counting mode, the set unit will be automatically stored when turning the machine on next time.
BACKLIGHT OPERATION
1. Two backlight modes are available here: "No backlight" mode and "auto-backlight” mode. The "No backlight" will
never show the backlight under any condition. The "auto-backlight" mode will light up the backlight when any key is
pressed or when the weight on the scale is more than 5d. Five seconds later, the light will extinguish after the weight
comes to "0".
2. Under the mode of weight measuring, you will enter into the other backlight mode by keeping pressing
key. After
setting the mode, the scale will automatically keep the backlight mode set previously when you turn the scale on
again.
CHARGE THE BATTERY
When the under voltage indicator is glittering, it shows the insufficient power and you need to recharge it in time. Con-
nect to the power supply to make the AC indicator light up. This stands for it’s charging now. The average charging
time is 12 hours.
ELECTRIC QUANTITY INDICATION
1. When the under voltage glitters, it shows the insufficient power and need recharging in time.
2. If the display screen does not show or shows "Lo",this means The battery is in the self-protection state, and you
should charge it in time and then you can use it.
To Next Page
Loading...
Need help?
General
