ENUSER’S MANUAL DSC
22
6. OPERATION
HORIZONTAL ADJUSTMENT
The level of the scale should be checked firstly. Adjust the four feet to center the bubble on the scale.
WEIGHING
Turn the scale on. The display screen will show number 1 to 9 for self-testing. After that, the three display screens will
show “weight”, “unit weight” and “total quantity”. Now put the product in the middle of the scale. The weight screen
will show the weight and a stable signal “o”. Input the weigh unit corresponding to the product to the unit weight
screen. The total quantity screen will automatically calculate and display the correponding total quantity.
ZERO
When no product or slight weight on the scale, you can press
back to zero. When the product weight is 10% heavier
than the maximum weight, the
key will be ineffective.Tare
Put the package on the scale and press
to return to zero, its weight can be eliminated, if there is a signal of , it
indicates that the weight has been deducted. After removing all items and package form the scale, if there is a display
of weight of package in a negative number on the weight space, press the key
and and the weight will run back
to zero.
PIECES NUMBER SET
Put samples of the products on the scale. The weight screen will show the weight. Press numeral key to input sample
number and the unit weight will display this number.
If press incorrectly, you can press
and input again. Press to confirm and the unit weight will be automatically be
computed. Now the unit weight screen, shows samples’s unit weight and the total quantity display screen shows the
sample’s quantity. Then you can sart counting now.
UNIT WEIGHT SET
Counting
When counting, if you already know the unit weigh of the product, you can press the numeral key to input tje unit wei-
ght directly. And when you put the product on the scale, the total quantity screen will display the prduct’s total quantity.
TARE PRESETTING
If you already know the tare of the product, then after pressing
input the tare value and press again for confir-
mation. At this point, the weight screen will show the presetted unit weight. And automatically the weighed product has
already been tared. You can also press
clear the presetted tare.
ACCUMULATION
In weighing and couting mode, press
to accumulate weight and total quantity. The weight screen displays accumu-
lated weigh; the unit weight screen displays accumulated number. You can accumulate the next number after taking the
accumulated product off and the screen back to zero.
Press
to see the accumulated records and press it once again back to the normal weighing and numbering mode.
Under the state of accumulating display, you can press
to clear all the accumulated records.
WARMING PRESETTING
When counting, if you want to set the upper and lower limit, press the
key, then the weight screen will show the
upper limit information “-HI-”. Press the numeral key to input the upper limit value and display it in the unit weight
screen. Then press
again to confirm and go into the lower limit set. The weight screen shows the lower set in-
formation “-Lo-”. And press the numeral key to input the lower limit value and display it in the total quantity screen.
To Next Page
Loading...
Need help?
General
