Bazzaz ZFi User Manual

INSTALLATION INSTRUCTIONS
DUCATI HYPERMOTARD 821 | 2014-2015
F198 | T198
WARNINGS > USING
• Use only in race or other closed-course applications and never on public roads.
• Z-Fi products are not certied by the California Air Resource Board (CARB) for
use on CA highways.
WARNINGS > INSTALLING
• We strongly suggest that an experienced technician install this product.
• Read through all instructions before beginning installation.
• This document is intended for use by qualied technicians.
• This is not a replacement for the factory Engine Control Unit (ECU).
• Refer to a factory service manual for more specic stock component
identication/location information and removal/assembly procedures.
GETTING HELP
• Factory support is available in the US at 909-597-8300.
• For fastest support outside of the US, nd your local importer at bazzaz.net.
1>READ
UNLEASH.
THE SMARTEST PERFORMANCE TUNING TECHNOLOGY
R
FUEL + QS + TRACTION CONTROL
FUEL MANAGEMENT

Bazzaz ZFi Specifications

General

Brand	Bazzaz
Model	ZFi
Category	Motorcycle Accessories
Language	English

Summary

Read and Warnings

Installation Warnings

Important safety and procedural warnings for installing the product.

Usage Warnings

Guidelines for safe and legal operation of the product.

Remove Components

ECU Disconnection Warning

Crucial instruction not to disconnect the factory Engine Control Unit during installation.

Secure Control Unit and Harness

Harness Routing and Unit Placement

Instructions for routing harnesses and securing the control unit.

Connect Components

Front Injector Connection

Procedure to connect the Bazzaz front injector harness inline.

CKPS Connection

Procedure to connect the Bazzaz CKPS connectors inline.

TPS Connection

Connect Components (Cont.)

Rear Injector Connection

Rear Wheel Speed Sensor Connection

Neutral Sensor Connection

Tail Light Connector Connection

Ground Connection

Quickshift Installation (Z-Fi TC Only)

Quickshift Switch and Rod Installation

Steps for installing the Bazzaz shift switch and rod linkage.

System Check and Software Setup

Software Download and Connection

Download, install, and connect the Bazzaz Z-Fi Mapper software.

Map Selection and Verification

Input Verification