5.6
1. Next, locate the factory rear wheel speed
sensor connectors, which can be found
mounted to the frame on the right hand
side behind and below the rear set.
2. Disconnect the factory rear wheel speed
sensor connector and install the Bazzaz
speed amplier in line.
3. Connect the remaining lead to the Bazzaz
harness.
5>CONNECT (CONT.)
5.7
1. Locate the white tail light connector in
the tail section of the bike.
2. Route the Bazzaz power/ground lead
towards the tail section of the bike.
3. Separate the factory yellow wire and use
the supplied scotchlok to crimp onto the
yellow wire.
4. Connect the Bazzaz power connector.
SECTION 6>CONNECT, AND 7>QUICKSHIFT ARE FOR USE WITH THE
BAZZAZ Z-FI TC ONLY!! FOR Z-FI, PLEASE SKIP FORWARD TO
SECTION 8>O2 ELIMINATION
5.8
1. Locate the factory negative battery
terminal and install the Bazzaz ground
lug.
FACTORY
BAZZAZ
FACTORY
BAZZAZ
To Next Page
Loading...