75.5959.01 LZR-FLATSCAN SW QSG 20180627 Page 1 of 475.5959.01 LZR-FLATSCAN SW QSG 20180627 Page 1 of 4
QUICK GUIDE
MOUNTING
LZR
®
-FLATSCAN SW
ENGLISH
1
Safety sensor for full- and low-energy automatic swing doors
(US version)
Only trained and
qualified personnel are
recommended to install
and set up the sensor.
Always test for proper
operation before leaving
the premises.
The door control unit
and the header cover
profile must be correctly
grounded.
Visit www.BEAinc.com
for full User’s Guide.
Do not remove the laser
window protection during
construction.
Position mounting base on door
frame and mark and drill holes.
Remove cover, pass cable
through, and secure sensor to
mounting base.
Connect black plug to black
connector.
Tighten lock screw.
Secure mounting base to door
frame.
Drill pass-thru hole in mounting
base and route master/slave
cable.
If installing only one sensor (low-energy, approach side), disregard steps associated with the pass-thru cable.
READ BEFORE BEGINNING INSTALLATION & SET-UP
!!
For applications requiring a spacer, first mount spacer to door, and then mount mounting base to spacer.
To Next Page
Need help?
General
