TIME
COUNT
To display
time'from
the 12-hour clock, go to the Manual Mode first.
Then:
PRESS:
The display shows hours, minutes and
seconds. If an "E" appears, power has
been interrupted and the clock should be
reset.
To set the clock
to 9:02:03 when in the TIME mode
PRESS:
101
191
101
121
101
13]
[El
and Read: 9.02.03
NOTE: All six digits must be entered.
You may also scan or search with the time and channel number being
displayed.
To remove time
from the display: PRESS:
To display time
when the switch is turned
"OFF",
PRESS:
PRIORITY
This selectable feature will permit you to hear channel
1
any time it is
active, regardless of any other signals being received at that time.
Put your favorite frequency in channel
1.
Then:
PRESS:
lPriorityl
"P" is displayed
To de-select Priority
PRESS:
-1
again. "P" disappears
AUXILIARY
To selectively control accessories
attached to the Auxiliary ter-
minal on the rear apron, go to the desired channel manually. Then:
To de-select Auxiliary
PRESS: Dot disappears.
See "Auxiliary Function" section on Page 15.
13
To count
the number of times a channel has received a signal (up to
99). go to that channel manually, for example, 34:
I
PRESS:
/I
Channel 34 is displayed
PRESS:
I
Count
I
The count number will show at the right
end of the display.
To erase count
from memory
PRESS:
-1
The count number is displayed
PRESS: (Decimal Point), channel and frequency are
displayed
I
PRESS:
counter will display 00
To return to manual
without erasing count
DELAY
Your scanner may be programmed to pause for about two seconds
after
a
transmission on any selected channel. This is useful when both
sides of a conversation are transmitted on the same frequency.
To program Delay
on a selected channel
PRESS:
-1
The "d" will be displayed. The channel
will hold for 2 seconds after the signal
ends.
To de-select delay
PRESS:
1-1
The "d" disappears. Scanning will begin
immediately at the end of the signal.
Delay will also hold for 2 seconds in Search, if such a delay is desired.
14
To Next Page
Loading...
