Beastx MICROBEAST PLUS - Page 22

Governor menu point B - Motor o/Idle position
Using an electric heli move the throttle to the position at which the motor is just before to start running, i.e. by adding throttle
until the motor starts to turn and then reducing the throttle a little. With a nitro/gas heli move the throttle to a stable idle
position.
Menu LED B ashes
Status LED o
Move throttle to position at which the motor is just before to
start running (electric heli) or idle position (nitro/gas heli)
Press button briey
Status LED blue
when throttle
position registered
Governor menu point C - Full throttle position
Move throttle to maximum position. Note: In electric governor mode the throttle input will not be passed to CH5 output to
prevent from motor damage by running the motor without load! Thus, you have to check before that the full throttle position
runs the motor at maximum speed in reality, i.e. by correctly programming your throttle end points in the transmitter or ESC.
Menu LED C ashes
Status LED o
Move throttle to maximum position
MAX RPM
Governor menu point D - Transmitter setup
Here we can set the desired rotor headspeed and throttle curves. The Status LED can be used to verify the transmitter setup.
When using an electric heli the throttle is completely independent from the thrust stick. The throttle curves are set to
horizontal lines which stand for a certain headspeed and governor operation mode. Using the ight mode switch you can
switch between the dierent curves/rpm presets in the transmitter.
The RPM Governor for nitro/gas models can be operated in two dierent ways: One possibility is to operate the governor
using the throttle channel similar to the electric mode. Only dierence here is that the the range below 50% throttle is used
to manually control the throttle servo, i. e. for starting the motor. The range above 50% activates the governor and presets a
specic rotor headspeed just like in electric mode.
Motor o
• Throttle 0% over
the entire range
Idle up
• Throttle set between
15% and 100%
equals headspeed of
600 - 4000rpm
• +5% = +200rpm
100%
0%
Autorotation
• Motor o
• When switching back
to idle up motor will
restart quickly
10%
Status LED blueStatus LED o
Status LED red
or purple
50%
2000rpm
Status LED blue
when throttle
position registered
Press button briey