Beastx MICROBEAST PLUS - Menu Overview

WWW.BEASTX.COM
MENU OVERVIEW
FIRMWARE VERSION 4.1
SETUP MENU
(Menu LED solid)
o
flashing
purple
purple
flashing
red
red
flashing
blue
blue
flashing
red/blue
A
Device orientation
horizontal
socket in front
vertical
socket in front
hor. inv.
socket in front
vert. inv.
socket in front
horizontal
socket at back
vertical
socket at back
hor. inv.
socket at back
vert. inv.
socket at back
B
Swashplate servo
update rate
User defined 50 Hz* 65 Hz 120 Hz 165 Hz 200 Hz
C
Rudder servo center pulse User defined 960 μs 760 μs 1520 μs*
D
Rudder servo update rate User defined 50 Hz* 165 Hz 270 Hz 333 Hz (560 Hz)
E
Rudder servo limit Use rudder stick to move servo to right endpoint and wait, then left endpoint and wait (or vice versa).
F
Tail gyro direction normal* inverted
G
Swashplate servo trim reference position Servo CH1 Servo CH2 Servo CH3
H
Swashplate mixing type User defined mechanical 90° 120°* 140° 135°/140°(1:1)
I
Swashplate servo directions nor | inv | inv nor | nor | inv* nor | inv | nor nor | nor | nor
J
Swashplate servo throw Use aileron stick to adjust 6° cyclic pitch on the roll axis to one direction (blades aligned with fuselage).
K
Collective pitch
Set collective stick to max/min position and use aileron stick to adjust desired pitch.
Set pitch direction by rudder stick input: Status-LED blue = positive pitch, red = negative pitch.
L
Swashplate servo limit Move aileron, elevator and thrust stick. Adjust maximum limit by rudder stick input.
M
Swashplate gyro directions inv | inv inv | nor nor | inv nor | nor*
N
Internal RPM Governor Governor off* electric heli nitro/gas heli
GOVERNOR SETUP MENU
(Menu LED ashing slowly)
o
flashing
purple
purple
flashing
red
red
flashing
blue
blue
flashing
red/blue
A
Test mode
„nitro/gas heli“: Status-LED blue when magnet passes sensor
„electric heli“ : Status-LED red when motor is running
B
Motor o/Idle position
„nitro/gas heli“: throttle servo to (increased) idle position
„electric heli“ : throttle in „motor off“ position, just before motor starts
C
Full throttle position Set throttle channel/throttle servo to full throttle position.
D
Transmitter setup RPM Governor off
RPM Governor
maximum
RPM Governor
on
RPM Governor
autorotation
E
Signal divider 1 2 3 4* 5 6 7
F
Main gear ratio
(Sum out of F + G + H if not „User
defined“ at menu point F)
User defined 8 9* 10 11 12 13 14
G
+0.00 +0.20 +0.40* +0.60 +0.80
H
+0.00 +0.05 +0.10* +0.15
* Default setting