Becker S50II - Commissioning of the System; Checking the Running Direction; Setting the End Limits; Lower End Limit Setting


Operating Instructions
Control
Checking the running direction


 
If the running direction does not correspond to the arrow direction:


Setting the end limits




Lower end limit setting



Upper end limit setting



Setting the safety limit switches




Setting the function switch for pneumatic testing/electrical function cutoff

 
 
 

Setting the function switch for partial opening

 

 

Note
On principle, the precise adjustment of the limit positions is carried out with the  ne adjustment screw of
the respective control cam (please see also the operating instructions for the door drive).
Commissioning of the system