What to do if Beckhoff Industrial PC does not boot fully?
If your Beckhoff Industrial PC isn't booting completely, it may be due to a floppy disk or CD in the drive, or incorrect setup settings. Try removing any floppy disks or CDs and press any key to restart. Also, verify that the setup settings are correct.
Why is my Beckhoff CP6201 only partially working?
If your Beckhoff Industrial PC functions only partially, such as having no picture or a dark screen, but the disk drive responds when switching it on, this could indicate defective components within the Industrial PC.
What to do if I get a floppy disk or CD access error on Beckhoff Industrial PC?
If you're encountering a floppy disk or CD access error on your Beckhoff Industrial PC, the problem might be a faulty disk or CD, or a faulty disk drive. Try checking the disk or CD in another drive to see if it works.
Essential safety precautions for operating and handling the Industrial PC.
Specifies the intended industrial applications for the Panel PC.
Details on Fieldbus, Serial, DVI, USB, Network, and other interfaces.
Steps and considerations for mounting the Panel PC inside a control cabinet.
Step-by-step guide on how to physically mount the Panel PC using clamping levers.
Instructions for connecting the 24 VDC power supply and optional UPS.
Details the pin configuration for the 8-pole power and control connector.
Guidance on fitting cables and assembling connectors for power and control signals.
Specifies minimum cable cross-sections (1.5 mm²) for power supply connections.
Schematic illustrating the external switch and power supply connections.
Detailed instructions for safely switching the Industrial PC on and off.
Table of common faults, their causes, and recommended correction procedures.
General| CPU Cores | 4 |
|---|---|
| Power Supply | 24 V DC |
| Protection Class | IP65 |
| Touchscreen | Yes |
| Ethernet Ports | 2 |
| Interfaces | Ethernet, USB, Serial |
| Operating Temperature | 0°C to +50°C |
| Expansion Slots | 1 |
To Next Page
