To Next Page

To Previous Page

Product overview

EL28xx-xxxx20 Version: 2.2

2.2 EL2828

2.2.1 Introduction

Fig.14: EL2828

HD EtherCAT Terminals, 8 digital output channels, 24V

, 2A

The EL2828 digital output terminal connects the binary control signals from the automation device on to the

actuators at the process level with electrical isolation. The EL2828 is protected against polarity reversal and

processes load currents with outputs protected against overload and short-circuit. The EtherCAT Terminal

contains eight channels, consisting of a signal output and 0V, whose signal states are displayed by LEDs.

The power contacts are connected through.

The outputs are fed via the 24V power contact in the EL2828. The conductors can be connected without

tools in the case of single-wire conductors using a direct plug-in technique. The maximum total output

current of the terminal is 10A.

The HD EtherCAT Terminals (High Density) with increased packing density are equipped with 16 connection

points in the housing of a 12-mm terminal block.

NOTE

Watchdog settings

Please refer to section "Notes for setting the watchdog [}53]".

Beckhoff EL2809 User Manual

Questions and Answers: