Beckhoff PS1011-2410-0000 - Output

Technical data, mounting, wiring
PS1011-2410-0000 13Version: 1.0
3.4 Output
Output voltage Nom. DC 24V
Adjustment range Min. 24-28V Guaranteed value
Max. 30V
2)
In end position of the potentiometer, clockwise.
Factory settings typ. 24.1V ±0.2%, at full load (cold device)
Line regulation Max. 5mV Between 90 and 264Vac
Load regulation Max. 100mV Between 0 and 10A, static value, see Fig. Output voltage over output current, typ.
Residual ripple and
ripple voltage
Max. 100mVpp Bandwidth 20Hz to 20MHz, 50Ohm
Output current Nom. 10A At 24V and an ambient temperature below 55°C, see Fig. Output current over ambient
temperature
Nom. 6.25A At 24V and an ambient temperature below 70°C, see Fig. Output voltage over output cur-
rent, typ.
Nom. 8.6A At 28V and an ambient temperature below 55°C, see Fig. Output current over ambient
temperature
Nom. 5.4A At 28V and an ambient temperature below 70°C, see Fig. Output voltage over output cur-
rent, typ.
Output power Nom. 240W Ambient temperature below 55°C
Nom. 150W Ambient temperature below 70°C
Overload characteris-
tics
Continuous
current
Output voltage > 13Vdc, see Fig. Output voltage over output current, typ.
Hiccup mode
1)
Output voltage < 13Vdc, see Fig. Output voltage over output current, typ.
Short circuit current Min. 11A Load impedance 50mOhm, see Fig. Output voltage over output current, typ.
The discharge current of the output capacitors is not included.
Max. 15A Load impedance 50mOhm, see Fig. Output voltage over output current, typ.
The discharge current of the output capacitors is not included.
typ. 4.8A Average current (rms), load impedance 50mOhm, see Fig. Output voltage over output
current, typ.
Output capacity typ. 2,850µF Included in the power supply
1)
Hiccup mode
In case of severe overload (when the output voltage drops below 13V) the power supply delivers a continuous output current for 2-5
seconds. The output is then switched off for approx. 1 second before a new start attempt is automatically made for 1 second. This cycle
is repeated as long as the overload exists. The device starts operating normally again once the overload has been rectified.
2)
This is the maximum output voltage that can occur in the end position of the potentiometer in clockwise direction due to tolerances. It
is not a guaranteed value that can be achieved. A typical value is 28.5V.
Fig.4: Output voltage over output current, typ.; short circuit at output, hiccup mode