7LEAK TEST PROCEDURE
LEAK TEST PROCEDURE
• Ensure all gas valves are in the ‘OFF’ position�
• In a small container, mix a solution of water and
detergent or soap�
• After connection of the hose, turn on the gas supply at
the gas bottle or mains as appropriate�
• Using a brush apply the solution to the gas connection
points and look for bubbles forming�
• Bubbling will indicate a leak�
• Turn off the gas supply and re-tighten the joint� Repeat
the leak test�
• If the leak persists, turn off the gas at the isolation
valves and contact a licensed gas fitter to correct�
Leak test procedure
Leak test
points
Check hose
for signs of
abrasions, cracks
or leaks
To Next Page
Loading...
