Beem 351201 - Cleaning and Care; Cleaning the Grinder Shaft

29 EN
Cleaning and Care
PLEASE NOTE!
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These can damage the surface.
1. Clean the permanent fi lter, the fi lter insert and the thermal jug (6) after every use with mild
detergent and warm water or in the dishwasher.
2. If necessary, wipe down the coffee bean compartment (2) and the lid (1) with a damp cloth.
3. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to
remove more intense soiling.
4. Check the mains cable regularly for any damage.
Cleaning the Grinder Shaft
1. Remove the coffee beans from the coffee bean compartment (2). (Apart from the few
beans that you cannot reach by hand.)
2. Insert the permanent fi lter into the fi lter insert.
3. Press the
button (18) to switch on the device. The grinding process will start.
4. Once the rest of the coffee beans have been ground – you can tell this from the change in
the grinding noise – stop the grinding process by pressing the
button again.
5. Take out the coffee bean compartment: To do this, turn it a little anticlockwise until it
disengages (Picture C1). Lift it off.
6. Move the grinding fi neness dial (8) to the RELEASE position.
7. Pull out the top part of the grinder (3) by the small handle (Picture C2).
8. Clean the grinder shaft and the grinder with the cleaning brush that is supplied.
9. Reinsert the top part of the grinder and press it down. Make sure it is in the correct posi-
tion (arrow marking). Fold the handle down again.
10. Adjust the grinding fi neness dial back to a grinding fi neness. The grinder is locked again.
11. Place on the coffee bean compartment at an angle and turn it clockwise a little until it
engages.
12. Open the fi lter compartment (5).
13. Clean the permanent fi lter.
14. Also clean the grinder shaft from below with the cleaning brush.