UK UK
12 13
k
m
09
• Take the diagonal belt out of
rear, belt guide (o).
• Undo the car seatbelt buckle
and take lap belt (l) out of belt
guide (m).
To ensure your baby’s safety, check that:
• shoulder belt (e) fits the baby’s body
closely without constricting the baby and
the belt is not twisted.
• the position of the headrest is correctly
adjusted.
• buckle tongues (i) are locked in place in
belt buckle (e).
RReemmoovvaall ffrroomm tthhee vveehhiiccllee
IInnssttaallllaattiioonn iinn ccaarr
• Tighten lap belt (l) by pulling on diagonal belt (n) in the
direction of the front of the vehicle.
• Pull diagonal belt (n) behind the head end of the infant car
seat.
Note! Do not twist the vehicle seatbelt while doing this.
• Route diagonal belt (n) through the rear belt guide (o).
• Tighten diagonal belt (n).
Note! Diagonal belt (n) must be routed through rear, belt guide
(o).
• Now swing the carrying handle (a) with both buttons (b)
pressed, into the vehicle position A .
WARNING! It may be that buckle part (k) of the car seatbelt is
too long so t
hat is reaches the belt guides of the infant car seat.
This means that the infant car seat cannot be fastened tightly. If
this is the case, choose another seat in the car for the infant car
seat.
h
e
(( ))ii
Correct securing of your baby
o
n
b
a
• Tighten lap belt (l) by pulling on diagonal belt (n) in the direction of the front of
the vehicle.
• Pull diagonal belt (n) behind the head end of the infant car seat.
NOTE! Do not twist the vehicle seatbelt while doing this.
• Route diagonal belt (n) through the rear belt guide (o).
• Tighten diagonal belt (n).
NOTE! Diagonal belt (n) must be routed through rear, belt guide (o).
• Now swing the carrying handle (a) with both buttons (b) pressed, into the
vehicle position A .
WARNING!
It may be that buckle part (k) of the car seatbelt is too long so that is reaches the belt
guides of the infant car seat. This means that the infant car seat cannot be fastened
tightly. If this is the case, choose another seat in the car for the infant car
seat.
Removal from the vehicle
• Take the diagonal belt out of rear,
belt guide (o).
• Undo the car seatbelt buckle and take lap
belt (l) out of belt guide (m).
Correct securing of your baby
To ensure your baby’s safety, check that:
• Shoulder belt (e) ts the baby’s body closely without
constricting the baby and the belt is not twisted.
• The position of the headrest is correctly adjusted.
• Buckle tongues (i) are locked in place in belt buckle (e).
CORRECT INSTALLATION OF THE INFANT CAR SEAT
To ensure your baby’s safety, check that:
• The infant car seat is secured with the child facing the rear of the car (the child’s feet
point towards the backrest of the infant car seat).
• The infant car seat is only used on the front passenger seat if there is no front airbag
that can impact on the infant car seat.
• The cat seat is fastened with a three-point automatic infant car seat belt.
• Lap belt (l) runs through the two belt guides (m) on both sides of the infant car seat.
• Diagonal belt (n) runs through belt guide (o) on the backrest of the infant car seat.
• Car seatbelt buckle (k) is not touching belt guide (m).
• The car seatbelt is taut and not twisted.
• Swing the carrying handle into the vehicle position A.
NOTE! The infant car seat may only be used on a front facing seat that has been tted
with a three-point safety belt and is approved under ECE R16.
Opening the sun canopy
Care
To ensure your baby’s safety, check that:
• the infant car seat is secured with the child facing the rear of the
car (the child’s feet point towards the backrest of the infant car
seat).
• the infant car seat is only used on the front passenger seat if
there is no front airbag that can impact on the infant car seat.
• the DK791 is fastened with a three-point automatic infant car
seat belt.
• lap belt (l) runs through the two belt guides (m) on both sides of
the infant car seat.
• diagonal belt (n) runs through belt guide (o) on the backrest of
the infant car seat.
• car seatbelt buckle (k) is no
t touching belt guide (m).
• the car seatbelt is taut and not twisted.
• Swing the carrying handle into the vehicle position A.
Note! The infant car seat may only be used on a front facing seat
that has been fitted with a three-point safety belt and is approved
under ECE R16.
m
m
k
CCoorrrreecctt iinnssttaallllaattiioonn ooff tthhee iinnffaann tt ccaarr sseeaatt
Unfold the sun canopy by pulling
gradually on the plastic cover. To
fold up, push the sun canopy back
to its starting position.
In order to ensure that your infant car seat provides the maximum
protective effect you must observe the following:
• All important parts of the infant car seat should be checked
regularly for damage so that all mechanical components function
without problems.
• It is absolutely essential to ensure that the infant car seat is not
jammed between hard objects such as vehicle doors, seat rails
etc., because this can lead to damage.
• After exposure to mass
ive forces (e.g. after a collision), it is
essential that the infant car seat is checked by the manufacturer.
Note! It is advisable to buy an additional cover on purchasing a
dk790 so that this seat can continue to be used even when the
cover is being washed and dried.
What to do after an accident
An accident can cause damage to the DK791 that is not visible to
the naked eye. Please exchange the seat without fail after an
accident. In case of doubt please contact the retailer or
manufacturer.
o
n
k
m
l
k
m
09
• Take the diagonal belt out of
rear, belt guide (o).
• Undo the car seatbelt buckle
and take lap belt (l) out of belt
guide (m).
To ensure your baby’s safety, check that:
• shoulder belt (e) fits the baby’s body
closely without constricting the baby and
the belt is not twisted.
• the position of the headrest is correctly
adjusted.
• buckle tongues (i) are locked in place in
belt buckle (e).
RReemmoovvaall ffrroomm tthhee vveehhiiccllee
IInnssttaallllaattiioonn iinn ccaarr
• Tighten lap belt (l) by pulling on diagonal belt (n) in the
direction of the front of the vehicle.
• Pull diagonal belt (n) behind the head end of the infant car
seat.
Note! Do not twist the vehicle seatbelt while doing this.
• Route diagonal belt (n) through the rear belt guide (o).
• Tighten diagonal belt (n).
Note! Diagonal belt (n) must be routed through rear, belt guide
(o).
• Now swing the carrying handle (a) with both buttons (b)
pressed, into the vehicle position A .
WARNING! It may be that buckle part (k) of the car seatbelt is
too long so t
hat is reaches the belt guides of the infant car seat.
This means that the infant car seat cannot be fastened tightly. If
this is the case, choose another seat in the car for the infant car
seat.
h
e
(( ))ii
Correct securing of your baby
o
n
b
a
m
l
k
n
o
k
m
09
• Take the diagonal belt out of
rear, belt guide (o).
• Undo the car seatbelt buckle
and take lap belt (l) out of belt
guide (m).
To ensure your baby’s safety, check that:
• shoulder belt (e) fits the baby’s body
closely without constricting the baby and
the belt is not twisted.
• the position of the headrest is correctly
adjusted.
• buckle tongues (i) are locked in place in
belt buckle (e).
RReemmoovvaall ffrroomm tthhee vveehhiiccllee
IInnssttaallllaattiioonn iinn ccaarr
• Tighten lap belt (l) by pulling on diagonal belt (n) in the
direction of the front of the vehicle.
• Pull diagonal belt (n) behind the head end of the infant car
seat.
Note! Do not twist the vehicle seatbelt while doing this.
• Route diagonal belt (n) through the rear belt guide (o).
• Tighten diagonal belt (n).
Note! Diagonal belt (n) must be routed through rear, belt guide
(o).
• Now swing the carrying handle (a) with both buttons (b)
pressed, into the vehicle position A .
WARNING! It may be that buckle part (k) of the car seatbelt is
too long so t
hat is reaches the belt guides of the infant car seat.
This means that the infant car seat cannot be fastened tightly. If
this is the case, choose another seat in the car for the infant car
seat.
h
e
(
)
i
i
Correct securing of your baby
o
n
b
a
m
l
k
n
o
To Next Page
Loading...