Eltropol 300
13
Note
• Polishing can start before the operating
temperature is reached. After 15 minutes, the
Wirolyt has already reached approx 30°C. The
bath continues to heat up during polishing.
• The necessary polishing time and current strength
are both calculated by the unit. These are
influenced by the size of the object and the bath
temperature. If required, the settings may be
adjusted manually:
a) The polishing time may be set anywhere
between 60 seconds (00:60) and 12 minutes
(12:00).
b) During polishing the current strength is
indicated by the LEDs (ammeter function). In the
default setting (level 3 = 100%) the current may
attain a maximum of 10 A, however this is only the
case when polishing two large objects in a hot
bath. The current may be manually limited to 70%
(level 2) or 50% (level 1) of the calculated
current. The number of LEDs illuminated changes
according to level. – After each polishing the unit
automatically returns to level 3!
• The polishing process can be interrupted by
pressing the Start button.
Press again to call up the polishing time calculated
at the outset (not the remaining polishing time).
This may now be altered manually. Press the Start
button again to start polishing with this setting.
• Uninterrupted polishing may cause the permitted
bath temperature to be exceeded. The unit then
displays the error message “E30”. Having
switched off the unit, wait approx. 1 hour before
switching it on again to resume polishing.
• An integrated fan switches on automatically, as
necessary, to cool down the unit electronics.
To Next Page
Loading...
