Bego Eltropol 300 - Polishing Process; Starting and Operating the Unit

Eltropol 300
12
Polishing
Only operate the unit when it is closed.
The fumes are a health hazard.
• Switch on the unit using the main switch:
- 1 alarm tone;
- display briefly shows the software version,
then 0:00;
- heating the bath: the 5 LEDs light up in
succession – “chaser” effect. After a maximum
of 25 minutes the operating temperature of
approx. 40°C is reached: the LEDs go out.
• Secure object to be polished.
• Press the Start button:
- the display indicates the polishing time
calculated by the unit (according to object size
and bath temperature).
The polishing time can also be altered using the
plus or minus keys.
• Start polishing: press the Start button again:
- the remaining polishing time is indicated on the
display (countdown meter);
- the strength of current during polishing is
indicated by the 5 LEDs.
The current strength can also be altered using
the plus or minus keys as required.
• After polishing:
- triple alarm tone;
- display shows 0:00.
• Remove the object holder with the polishing object
and rinse off under running water.
If the object is to be polished a second time,
allow to dry thoroughly!
Never add water to acid!
• As a general rule, polishing must be effected in two
stages. The polishing object must be positioned
anew in the bath each time (rotate 180°).
• If the unit is not needed for longer periods, switch
it off.
Start
min
A
10
8
6
4
2
+
0:00
H O 2
Avoid contact with skin and eyes!
Risk of blinding!
Wear safety glasses and safety gloves!
Never add water!