Eltropol 300
15
Do not tilt the device to empty it!
Injuries are possible.
The device will be damaged.
• Having drained the tube, replace the stopper and
fasten securely with the clamp.
Never use water to clean the empty polishing
bath!
Rinse out with Wirolyt if necessary.
• Fill the polishing bath with approx. 2 litres Wirolyt
- see section “Filling”.
• Switch the unit on at the main switch:
The bath begins to heat up. (If the walls of the
polishing bath are still warm it can take a few
minutes for the heating process to begin.)
• After filling, the monitoring of the polishing
solution needs to be reactivated. Press the button
and keep it depressed until you hear a long alarm
tone.
Care and maintenance
• Wipe the outside of the unit down with a damp
cloth as necessary.
• If the bath is empty, the inside of the unit may also
be cleaned using a dry cloth. Caution! Polishing
solution dregs contain acid and destroy the cloths
used!
Avoid contact with skin and eyes!
Risk of blinding!
Wear safety glasses and safety gloves!
Never add water!
To Next Page
Loading...
