Eltropol 300
6
Eltropol 300 is designed for the electrolytic polishing
of Co-Cr partial denture bases. One or two objects may
be polished simultaneously.
l Intelligent technology
By gauging the electric current, the Eltropol 300
automatically proposes the optimum polishing time
required according to object size and the temperature
of the bath. If necessary, the proposed polishing time
and current may be adjusted manuaIly.
l Innovative heating concept
The polishing bath is brought to operating temperature
and subsequently monitored using a unique
procedure. This means that there are no unreliable
heating elements and the bath heats up more quickly.
l Wear reduction measures
Due to the use of stainless steel instead of copper, the
object holders are subject to considerably less
decomposition in the glossing fluid than the usual
1 Main switch / fuse / mains connection
2 Power cable (EU / USA)
3 Control panel
4 Lid/cover
5 Voltage selector switch (230 V / 115 V)
Polishing bath
1 Container for utensils (not for water!)
2 Contact for supplementary cathode
3 Cathode
4 Clips for object holder
5 Heating element
Object holder
1 Object hook
2 Crocodile clip with holder
3 Supplementary cathode
Unit description
3
4
5
1
2
copper hooks.
Other measures designed to minimise wear are a
reduction in the number of moving parts by means of a
magnetic stirrer and an outer casing made of stainless
steel with an additional coating of electrolyte-resistant
paint.
l Simplified bath emptying
The control panel indicates when it is time to change
the polishing solution. A drainage tube on the back of
the unit makes it convenient and safe to drain the
solution directly into a waste canister.
l Safety
The operating temperature of approx. 40°C is
monitored electronically. At temperatures exceeding
60°C the unit displays an error message and cuts out.
An additional independent control circuit causes the
unit to shut down automatically at temperatures over
70°C. The unit may only be switched on again once it
has cooled down.
Polishing bath Object holder
1
2
3 4
5
1 2 3
2
To Next Page
Loading...
