Beha-Amprobe ProInstall-75 - General Device Specifications

24
General Specifications
Specification Characteristic
Size 10 cm (L) x 25 cm (W) x 12.5 cm (H)
Weight (with batteries) 1.3 kg
Battery size, quantity Type AA, 6 ea.
Battery type Alkaline supplied.
Usable with 1.2 V NiCd or NiMH batteries (not supplied)
Battery life (typical) 200 hours idling
Fuse T3.15 A, 500 V, 1.5 kA 6.3 x 32 mm (PN 2030852)
Operating Temperature -10 °C to 40 °C
Storage Temperature -10 °C to 60 °C indefinitely (to -40 °C for 100 hrs)
Relative Humidity 80 % 10 to 35 °C; 70 % 35 to 40 °C
Operating Altitude 0 to 2000 meters
Shock, Vibration Vibration to Class 3 per MIL-PRF-28800F
1 meter drop test, six sides, oak floor
Sealing IP 40
EMC Complies with EN61326-1
Safety Complies with EN61010-1
Overvoltage Category: 500 V/CAT III, 300 V/CAT IV
Measurement Category III is for measurements
performed in the building installation. Examples are
distribution panels, circuit breakers, wiring and cabling.
Category IV equipment is designed to protect against
transients from the primary supply level, such as an
electrical meter or an overhead or underground utility
service.
Performance EN61557-1, EN61557-2, EN61557-3,
EN61557-4, EN61557-6, EN61557-7. EN61557-10.
Pollution Degree 2
Maximum voltage between
any terminal and earth ground
500 V
Surge Protection 6 kV peak per EN 61010-1
Category Ratings and Usage
Part/Accessory Printed
CAT Rating
CAT II
250 V
CAT III
500 V
CAT IV
300 V
Electrical Installation Tester CAT III 500 V
CAT IV 300 V
√
√
√
√
√
√
ProInstall-TL-UK, British Mains Cord CAT II 250 V √
ProInstall-TL-Kit Remote Test Probe (red) CAT III 1000 V √ √ √
Test Lead (red/green/blue) CAT III 1000 V √ √ √
Test Probe (red/green/blue) CAT III 1000 V √ √ √
Alligator Clip (red/green/blue) CAT III 1000 V √ √ √
TL-75 Fused Test Probes:
(red/green/blue)
CAT III 1000 V
CAT IV 600 V
√
√
√
√
√
√