Feedback protection for stage monitors
FEEDBACK DESTROYER FBQ1000 Controls
Step 2: Controls
LED METER displays the output signal level. If the CLIP LED lights frequently,
lower the gain setting for the channel. In Total Bypass mode, the LED METER displays the input signal level.
STATUS LEDs display the status of the 12 individual filters for each channel. Active filters or EQs are displayed by a lit LED. A flashing LED
signifies that a filter is searching for feedback frequencies. Inactive filters are displayed by an unlit LED.
ENGINE L and R buttons select the left
(L) and right (R) audio channels. Press both buttons simultaneously to enter Couple mode, which allows both channels to be edited at the
same time.
FEEDBACK DESTROYER FBQ1000 Controls
Step 2: Controls
FILTER MODE button
accesses the four filter modes: Off (OF), Parametric EQ (PA), Single-Shot (SI), and Auto (AU).
JOG WHEEL scrolls through presets and adjusts parameter values.
To Next Page
Loading...
