Behringer FLOW 8 - Control Change (CC) Messages

Section
Input Ch. 1*
MIDI
Ch.
1*
Command
CC 7
MM.
Value
0,1
Max.
Value
127
Parameter
Channel LEVEL
(to MAIN)
Min. Value
OFF, -70 dB
Max. Value.
+10 dB
Notes
Comment
Value 0 = OFF, Value 1-
127 = the actual level
control
from -70 to +10 dB
“ CC 10 0 127
Channel
BALANCE
(to MAIN)
1.0 LEFT 1.0 RIGHT Value 64 = “0.0 CENTER”
CC 5 0 1-127 MUTE NO MUTE MUTE
Switch; value 0 =
“MUTE
OFF”; value 1-127 =
“MUTE
“ CC 6 0 1-127 SOLO NO SOLO SOLO
Switch; value 0 =
“SOLO
OFF”; value 1-127 =
“SOLO”
“ “ CC 1 0 127 EQ LOW -15 dB +15 dB
Continuous control; value
64 = “0.0 dB” (center
portion)
“ CC 2 “ EQ LOW MID “
“ “ (C3 “ EQ HI MID
“ “ CC 4 “ EQ HI “ “
“ CC 8 0 127 GAIN -20 dB +60 dB NOT on Ch. USB/BT Continuous control
“ “ CC 9 0 127 LOW CUT 20 Hz 600 Hz NOT on Ch. USB/BT Continuous control
CC 11 0 100-127 COMP 0% 100% NOT on Ch. USB/BT
Continuous control; values
101-127 = identical to
max.
value =100%
“ CC 12 0 1-127 48V OFF ON ONLY on Ch. 1 + 2
Switch; value 0 = “48V
OFF”; value 1-127 = “48V
ON”
“ CC 13 0 1-127
CHANNEL
STATUS
HIDDEN ACTIVE
Switch; value 0 =
“HIDDEN”
value 1127 = “ACTIVE”
“ “ C( 14 0,1 127
SEND LEVEL to
MON1
OFF, -70 dB +10 dB
Value 0 = OFF, Value 1-
127
= the actual level control
from -70 to +10 dB
“ CC 15 0,1 127
SEND LEVEL to
MON2
OFF, -70 dB +10 dB
“ CC 16 0,1 127
SEND LEVEL to
FX1
OFF, -70 dB +10 dB “
“ CC 17 0,1 127
SEND LEVEL
toFX2
OFF, -70 dB +10 dB
*Each Input Channel is assigned to one specific MIDI-Channel.
BUSSES