Behringer FLOW 8 - Bus and FX Control via MIDI

Section
MIDI
Ch.
Command
Min.
Value
Max.
Value
Parameter Min. Value Max. Value. Notes Comment
MAIN BUS** 8** C( 7 0,1 127 BUS LEVEL OFF, -70 dB +10 dB
Value° = OFF, Value 1-12
= the actual level control
from -70 to +10 dB
“ C( 10 0 127 BUS BALANCE 1.0 LEFT 1.0 RIGHT ONLY on MAIN BUS Value 64 = “0.0 CENTER”
“ C( 8 0 127 BUS LIMITER -30 dB 0 dB NOT on FX1/2 BUS Continuous control
(C11 0 127 9-BAND EQ 62 Hz -15 dB +15d8 NOT on FX1/2 BUS
Continuous control; value
64 = “0.0 dB”
(center postion)
“ “ CC 12 “
9-BAND EQ 125
Hz
“
“ “ CC 13 “ “
9-BAND EQ 250
Hz
“ „ “
“ CC 14
9-BAND EQ 500
Hz
“ “ “
CC 15 “ 9-BAND EQ 1 kHz “ “
“ C( 16 “ “ 9-BAND EQ 2 kHz “ “ “
“ (C17 “ 9-BAND EQ 4 kHz “ “
CC 18 “ “ 9-BAND EQ 8 kHz “ “ “
“ CC 19 “ “
9-BAND EQ 16
kHz
“ “
**Each BUS is assigned to one specific MIDI-Channel.
FX CONTROL
Section
MIDI
Ch.
Command
Min.
Value
Max.
Value
Parameter Min. Value Max. Value. Notes Comment
FX1 / FX2 13 / 14 Prog. Chg. 1 16 EFFECT PRESET 1 16
Program Change 0 &
ignored
“ “ CC 1 0 100-127 PARAMETER 1 0% 100%
Continuous control; values 1011
_71-21277==i en ta, t 0
max. value = 100%
“ a 2 0 1-127 PARAMETER 2 Value A Value B
Switch; MIDI value 0 = “Value A”;
MIDI value 1-127 = “Value B”
Each FX slot is assigned to one specific MIDI-Channel.
GLOBAL CONTROL