.
Section
MIDI
Ch.
Command
Min.
Value
Max.
Value
Parameter Min. Value Max.Value. Notes
I
Comment
SNAPSHOT 16 Prog. Chg. 1 16
Load MIXER
SNAPSHOT
1 16
Loading #16 =
RESET!
Program Change 0 & 17-127
= ignored; Presets = 1-15;
RESET = Prog. Chg. #16
FX1 /FX2 “ CC 1 0 1-127 FX MUTE NO MUTE MUTE
Mutes BOTH FX
Sends
Switch; value 0 = “MUTE
OFF”; value 1-127 = “MUTE”
Eli / FX2 Note 0 (C -1) Velocity 1 Velo. 127 TAP TEMPO 50 BPM 250 BPM See below!
lowest MIDI note for tempo
tapping; ignore Velocity 0,
any velo. btw. 1-127 = OK
> ALL global controls operate on MIDI-Channel 16.
Notes to TAP TEMPO:
1. Note On command will be used to control the FX tempo; Note Off will be ignored
2. Any Note Velocity from 1-127 is OK for triggering, Velocity 0 will be ignored (because it’s often misused as “note off” command)
3. Tempo calculation will be done by measuring the time interval between a repetitive hit of MIDI-Note 0 (same logic as for the hardware MUTE button on the mixer)
4. TAP TEMPO affects generally both FX slots, so it’s a “global tempo” (although at the moment ONLY FX2 slot makes use of the TAP function)
5. TAP TEMPO is only useable for delay/echo effects which offer this parameter (currently: FX2 > Presets No. 1-12)
Specifications
Mic Inputs
Type
2 x XLR, balanced
2 x XLR / 1/4″” TRS combo jacks, balanced
Mic E.I.N. @ +60 dB gain (20 Hz to 20 kHz)
@ 00 source resistance -125 dB A-weighted
@ 500 source resistance -124.5 dB A-weighted
@ 150 0 source resistance -124 dB A-weighted
6 Frequency response(-1 dB) 20 Hz to 20 kHz (-0.5 dB)
IGain range 20 dB to +60dB
Max. input level +19.5 dB gain
Impedance 10 Kt balanced, 5 Kt unbalanced
Signal-to-noise ratio
“89 dB A-weighted
(0 dBu in@ +10 dB gain)”
Distortion (THD+N) 0.003%, A-weighted
Phantom power +48 V, switchable
Line Input
Type 2 x 1/4″ TRS connector, balanced, channels SL / 7L .
Impedance 20 Id) balanced, 10 Id) unbalanced
Gain range -20 dB to +60 dB
Max. input level +19.5 dBu
Guitar (Hi-Z) Inputs
Type 2 x 1/4″ TRS connector, balanced, channels 6R / 8R
Impedance 2 MO balanced, 1 MO unbalanced
Max. input level +19.5 dBu
Guitar (Hi-Z) Inputs
Type 2 x 1/4″ TRS connector, balanced, channels 6R / 8R
Impedance 2 MΩ balanced, 1 MΩ unbalanced
Max. input level +19.5 dBu
Channel EQ
Low ±14.6 dB @ 20 Hz, shelving
To Next Page
Loading...
Need help?
General
