To Next PageTo Next Page
Need help?Do you have a question about the Behringer NX1000 and is the answer not in the manual?
General| Damping factor | 155 |
|---|---|
| Amplifier class | D |
| Frequency range | 20 - 20000 Hz |
| Built-in crossover | Yes |
| Audio output channels | - channels |
| Peak power per channel | 500 W |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Total Harmonic Distortion (THD) | 0.05 % |
| RMS power output per channel (4 Ohm) | 300 W |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power protection features | Overload |
| Power consumption (typical) | 150 W |
| Speakers connectivity type | XLR / 1⁄4\ |
| Purpose | Performance/stage |
| Cooling type | Active |
| Product color | Black |
| Connectivity technology | Wired |
Weight and Dimensions| Depth | 231 mm |
|---|---|
| Width | 483 mm |
| Height | 94 mm |
| Weight | 3300 g |
Lists essential safety guidelines for operation and maintenance.
Describes front panel buttons, LEDs, and input/output jacks.
Guides on powering on the unit and adjusting input levels.
Explains setting up two amplifiers for high and low frequencies separately.
Describes using one amplifier with an external crossover for frequency splitting.
Details maximum output power and channel configurations.
