To Next PageTo Next Page
Need help?Do you have a question about the Behringer NX4-6000 and is the answer not in the manual?
General| Amplifier class | D |
|---|---|
| Frequency range | 20 - 20000 Hz |
| Audio output channels | 4.0 channels |
| Peak power per channel | 1600 W |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Total Harmonic Distortion (THD) | 0.2 % |
| AC input voltage | 120 V |
| AC input frequency | 60 Hz |
| Power consumption (typical) | 620 W |
| Speakers connectivity type | XLR |
| Purpose | Performance/stage |
| Cooling type | Active |
| On/off switch | Yes |
| Product color | Black |
| Connectivity technology | Wired |
Weight and Dimensions| Depth | 316 mm |
|---|---|
| Width | 483 mm |
| Height | 94 mm |
| Weight | 6100 g |
Covers essential safety measures for operating and maintaining the amplifier.
Program dynamic EQ modules for frequency range adjustments.
Compensate phase cancellation using signal phase and delay.
Set crossover switches for LF, HF, and FULLRANGE modes.
Use separate amps for high and low frequencies.
Connect amplifier CH A output to subwoofers using specific cables and modes.
Configure the subwoofer to BIAMPING mode for proper operation.
Connect subwoofer output to mid/high-range speakers with 2-pole cable.
Set external crossover and route frequency signals to amplifier inputs.
Slide CROSSOVER switch to FULLRANGE on both amplifiers.
Choose BIAMP1 setting and set crossover frequencies.
Connect subwoofer and other speakers using appropriate cables.
Set HP/LP filters and gain for Bi-amping in DSP settings.
Set high-pass and low-pass filters and gain levels in DSP.
