Behringer ODYSSEY - Page 20

20
ODYSSEY
Rear Panel
(55) DC INPUT – connect the supplied DC
power adapter here. The power adapter
can be plugged into an AC outlet capable of
supplying from 100 V to 240 V at 50 Hz/60 Hz.
Use only the power adapter supplied.
(56) POWER – turn the synthesizer on or o.
Make sure all the connections are made before
turning on the unit.
(57) LED – this adjusts the brightness of the fader
LEDs from bright to o.
(58) MIDI IN – receives MIDI data from an external
source. This will commonly be another MIDI
keyboard, an external hardware sequencer, a
computer equipped with a MIDI interface, etc.
(59) MIDI OUT – sends MIDI data to
an application.
(60) USB PORT – This USB type B jack allows
connection to a computer. The ODYSSEY will
show up as a class-compliant USB MIDI device,
capable of supporting MIDI in and out.
USB MIDI IN – accepts incoming MIDI data
from an application.
USB MIDI OUT – sends MIDI data to
an application.
(61) PEDAL – an optional VOLUME footpedal can
be connected here, to vary the VCO-2 FM
modulation and the VCF if their switches are
set to the PEDAL position.
(62) PORTAMENTO Footswitch – an optional
footswitch can be connected here, to engage
or disengage the PORTAMENTO.
(63) MAIN OUTPUT LOW – connect this output to
the lower-level inputs of guitar ampliers or
mixers for example.
(64) MAIN OUTPUT HIGH – connect this output
to the line-level inputs of mixers, keyboard
ampliers, or powered speakers for example.
(65) EXT AUDIO INPUT – this input can be
connected to the line-level audio output from
an external audio device. The level can be
adjusted at the source, and it will play when
the keyboard or a sequencer pattern is played.
Low-level sources may need boosting to line-
level with an external pre-amplier or mixer.
(66) PHONES – connect your headphones to this
output. Make sure the PHONES volume knob is
turned down before putting on headphones.
(67) PHONES VOLUME – adjust the headphones
volume to a safe level before putting on
headphones or turning on the unit.
(68) CV/GATE/TRIGGER INPUTS and OUTPUTS –
these inputs and outputs allow the connection
of control voltage, gate and trigger signals
from compatible external devices such as
modular synthesizer equipment.
(55) (56) (57) (58) (59) (60) (61) (62) (63) (64) (65) (66) (68)(67)
(EN)
Step 2: Controls
ODYSSEY Controls