Behringer Ultra Octaver UO300 - Safety Instructions; Limited Warranty; Technical Specifications

2
ULTRA CHORUS UC200
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen
and remove the pedal cover. Be careful not to scratch the unit.
◊
◊ The UC200 has no on/o switch. As soon as you insert
the jack into the in connector, the UC200 begins running.
When not using the UC200, remove the jack from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located on the bottom.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualied servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
3. Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe’s Limited Warranty, please see
complete details online at musictribe.com/warranty.
4. Specications
In
Connector ¼" TS
Impedance 500 k
Out A
Connector ¼" TS
Impedance 1 k
Out B
Connector ¼" TS
Impedance 1 k
Power Supply
9 V , 100 mA regulated
Behringer PSU-SB
USA/Canada 120 V~, 60 Hz
China/Korea 220 V~, 50 Hz
U.K./Australia 240 V~, 50 Hz
Europe 230 V~, 50 Hz
Japan 100 V~, 50 - 60 Hz
Power connector 2 mm DC jack, negative center
Battery 9 V type 6LR61
Power consumption 30 mA