The changes made on the screen are immediately transmitted to the second
DCX2496 with ID 2.
Please look at the blue bar at the top of the window: Here you can observe which
DCX2496 is currently connected to the remote software. In the above case, it is
connected to our “second device” (with the device ID 2).
Example 4: PC to 2 DCX2496s (PC<RS485>1
st
DCX<RS485>2
nd
DCX)
1. Connect the first DCX2496 via its LINK A port (RS485) to the RS485 port of your PC
card. (This will only work with a true RS-485 card, not a standard network card like
those found in laptops!)
25
To Next Page
Loading...
