2. Connect the first DCX2496 via its LINK B port (RS485) to the LINK A (or B) port
(RS485) of the second DCX2496.
3. Push the TERM switch only on the second DCX2496 to ON.
4. Power up both DCX2496s and the PC.
5. Go to the first DCX2496 to SETUP page 6/6 (Miscellaneous)
select “DEVICE ID: 1”
select “PORT: LINK (RS485)”
11
6. Go to the second DCX2496 to SETUP page 6/6 (Miscellaneous)
select “DEVICE ID: 2”
select also “PORT: LINK (RS485)”
22
NOTE! All changes you have done on the SETUP page (like new port
or device ID select) will only be stored permanently if you change
to another menu page (e.g. OUT 1) before powering off the
DCX2496!
7. Start the Remote Editor Software on the PC.
8. Go to the “Connect” page
26
To Next Page
Loading...
