Behringer ULTRADRIVE PRO DCX2496 - Stereo Operation with Mono Subwoofer

21 ULTRADRIVE PRO DCX2496 User Manual
6.4 Stereo operation plus mono subwoofer
Output 4 usable as additional mono delay line output.
Output 5 + 6 usable as additional stereo delay line output.
XENYX X2222USB Mixing console
High (1)
EUROLIVE B1800X PRO
Passive mono subwoofer
SUM (A + B) signal
EUROPOWER EP2000
Stereo power amplier (mono bridged)
B815NEO
Left active
loudspeaker
B815NEO
Right active
loudspeaker
Right
Stereo output
Left
In A
Outputs: 1 2 3 (4, 5 and 6 not used)
In B
Low (3)
Fig. 6.4: Stereo operation plus mono subwoofer
A full-range stereo signal is sent to two active speaker cabinets for stereo reproduction. There is no need for a dedicated frequency separation because the crossover
and amplier in the active speaker are perfectly adapted to each other. However, to achieve more power in the bass, low frequencies are cut o in the active cabinets
and routed to a subwoofer. The power amp is set to mono-bridged mode and the SUM signal derived from In A+B is sent to the subwoofer. Outputs 4 to 6 can be used
as mono or stereo delay lines.