Behringer ULTRADRIVE PRO DCX2496 - 5-Way Mono Operation with Additional Mono Signal

28 ULTRADRIVE PRO DCX2496 User Manual
6.11 5-way mono operation plus 1 additional mono signal
XENYX X2222USB Mixing console
Mono out 1
RS-232
In A In B In A In B
1 2 3 4 5 6 Outputs Outputs: 6 5 4 3 2 1
EUROPOWER EP2000
Stereo power amplier
High (6) High (6)
High mid (5) High mid (5)
Mid (4) Mid (4)
Low mid (3) Low mid (3)
Low (2) Low (2)
In B signal (1) In B signal (1)
Left Right
EUROLIVE F1220A
Full range mono monitor
EUROLIVE B1800X PRO
Mono subwoofer
Stereo master
left channel
Mono out 2
Stereo master
right channel
LINK
(RS-485)
4-way
loudspeaker towers
(In A Signal)
Fig. 6.11: 5-way mono operation plus 1 additional mono signal (per stereo side)
Again, two ULTRADRIVE PROs can be remotely controlled from a notebook/PC by using our free CrossOverRemote Software.
This set-up is similar to the one described in chapter 6.10. Here, however, even ve frequency-optimized ways per stereo side are transmitted. The subwoofer has a separate
mono-bridged power amp, just like the sixth channel, whichcan be used independently and is controlled from the separate B input. In our example, one of these mono
channels is used for an individual subwoofer, while the the mono channel of the second ULTRADRIVE PRO drives a full-range stagemonitor.