(EN) Controls
(1) USB-C SOCKET – use this socket to update the
Victor’s rmware with the SynthTribe app, and to
control it using MIDI CCs. Please note that the Victor
does not respond to MIDI note on/o. It can also be
used to upload presets edited in the PRO-VS MINI.
(2) OLED DISPLAY – this display shows the Victor’s
waveforms when in operation, and patch names and
parameters during editing.
(3) DATA – use this control to set parameter values
during editing, and to select the required preset
memory during editing and playing.
(4) X/MOD – hold this button and use the DATA control
(3) to select the depth of external X-axis modulation
via the X-in socket (10). Short presses can be used to
scroll through pages while editing. LEDs (5) will all
light green while X Mod is being adjusted.
(5) LEDs – these LEDs indicate which menu page is
being displayed on the OLED display (2): Oscillator
A-D menu, Mix Envelope menu or Waveform
Oscilloscope. In Oscilloscope mode the DATA control
(3) can be used to scroll through the 32 presets.
(6) SAVE – hold this button to save edited presets to
onboard memory. Short presses can be used to scroll
through parameters while editing.
(7) Y/MOD – hold this button and use the DATA control
(3) to select the depth of external Y-axis modulation
via the Y-in socket (10). Short presses can be used to
scroll through pages while editing. LEDs (5) will all
light green while Y Mod is being adjusted.
(8) FREQ – hold this button and use the DATA
control (3) to set the frequency range. Ranges
1 – 8 represent a frequency range of C0 – C7 +/- 7
semitones. Range 9 represents an eight octave
range. Short presses can be used to scroll through
VICTOR Controls
(1)
(4) (6)
(7)
(9)
(10)
(11)
(14) (15) (16) (17)
(13)
(12)
(8)
(5)
(3)
(2)
21Quick Start Guide20 VICTOR
To Next Page
Loading...
