(EN) MENU PAGES AND OPTIONS
Use buttons 4 and 7 to scroll through the six menu pages, and
buttons 6 and 8 to scroll through the parameters. Parameters
are adjusted using the DATA control (3). Current page is
indicated by the relevant LED (5) being lit.
Pages 1 – 4: Oscillators A – D
The oscillators have three adjustable parameters:
• Wave (see table below)
• Coarse tuning (0 – 24 semitones upward)
• Fine tuning (0 – 99 cents upward)
WAVE
COARSE. FINE
036 DOME 2
00.07
Page 5: Mix Envelope
Page 5 has seven sub-pages, which are accessed by short
presses of buttons 6 and 8:
Sub-Page 1: Mix Envelope Loop
Select: O (default), 0 > 3, 1 > 3, 2 > 3, 0 <> 3, 1 <> 3 or
2 <> 3; where the numbers indicate the envelope points in
use. If O is selected then the other sub-pages will not be
accessible.
MAX ENV LOOP
2< - >3
Sub-Page 2: Mix Envelope Repeat
Select either 0 – 7 repeats or a continuous loop.
MIX ENV REPEAT
CONTINUOUS
Sub-Pages 3 – 7: Set Envelope Values
Each page represents an envelope point 0 – 4, and at each
one the joystick can be used to set the relative levels of
Oscillators A - D at that point.
MIX ENV POINT :0
a46 b49 c02 d01
Sub-Page 8: Set Envelope Rate
Use this page to set the rates for the four envelope points,
from 0 to 99.
R1 R2 R3 R4
09 22 52 56
49Quick Start Guide48 VICTOR
To Next Page
Loading...
