Behringer Victor - Page 27

will then be uploaded to the selected program memory.
If your le contains all 32 programs then all 32 will be
uploaded to their original locations.
HOW VECTOR SYNTHESIS WORKS
Unlike conventional synthesis, where oscillators are blended
together to produce the basis for a sound, Vector Synthesis
allows the balance of four oscillators to be continuously
adjusted by both the joystick and using the mix envelope.
The timbre of the sound can thus be changed subtly or
dramatically as you play, depending on the waveforms you
pick for each oscillator and how much mix automation you use.
When the waveform mix joystick is in its central position all
four oscillators have equal precedence. Moving the joystick
upwards will increase the level of oscillator B while decreasing
that of oscillator D; A and C remain the same. Equally moving
it to the left increases the level of oscillator A against C while
not aecting B and D. Therefore, for example, placing the
joystick between A and B (North West) would give an equal
amount of each of these oscillators while C and D will not
contribute. Moving laterally to South East decreases A and
B while increasing C and D proportionally, until A and B are
not heard.
The result is a sound that morphs within a 2D plane with
the joystick movement, mixed with the automation of
the mix envelope.
(ES) PÁGINAS DE MENÚ Y OPCIONES
Use los botones 4 y 7 para ir pasando por las seis páginas
de menú y los botones 6 y 8 para pasar por los distintos
parámetros. Para ajustar los parámetros use el control
DATA (3). La página activa es indicada por el piloto LED
correspondiente (5) iluminado.
Páginas 1 – 4: Osciladores A – D
Los osciladores tienen tres parámetros ajustables:
• Wave (onda - vea la tabla de abajo)
• Coarse (anación amplia. 0 – 24 semitonos
hacia arriba)
• Fine (anación precisa 0 – 99 centésimas
de semitono hacia arriba)
WAVE
COARSE. FINE
036 DOME 2
00.07
Página 5: Envolvente de mezcla
La página 5 tiene siete sub-páginas a las que puede acceder
con una pulsación rápida de los botones 6 y 8:
Sub-página 1: Bucle de envolvente de mezcla
Elija: O (valor por defecto), 0 > 3, 1 > 3, 2 > 3, 0 <> 3, 1
<> 3 o 2 <> 3; en el que los números indican los puntos de
envolvente en uso. Si elige el valor O ya no podrá acceder al
resto de sub-páginas.
53Quick Start Guide52 VICTOR