Behringer WASP DELUXE - Rear Panel; Output Section; Power Section

WASP DELUXE Controls
19
Quick Start Guide
CONTROL ENV.
(23) ATTACK knob controls the speed of the lter onset.
(24) DECAY knob controls how quickly the lter cuto
frequency decays.
(25) DELAY/REPEAT knob delays the onset of the lter attack
by up to 1 second.
OUTPUT Section
(26) VOLUME knob controls the nal volume at the MAIN
AUDIO and MAIN OUT jacks.
(27) PHONES knob controls the headphone volume at the ⁄"
TRS jack immediately above the knob.
MIDI Section
(28) USB PORT allows connection to a computer over a USB
type B connection. The WASP DELUXE will show up as a
class-compliant USB MIDI device, capable of supporting
MIDI in and out.
•
• USB MIDI IN - accepts incoming MIDI data from an application.
•
• USB MIDI OUT - sends MIDI data to an application.
(29) MIDI IN receives MIDI data from an external source over
a 5-pin DIN connector. This will commonly be a MIDI
keyboard, an external hardware sequencer, a computer
equipped with a MIDI interface, etc.
(30) MIDI THRU uses a 5-pin DIN jack is used to pass through
MIDI data received at the MIDI INPUT. This data will
commonly be sent to another MODEL D synthesizer to run
a Poly Chain or to a drum machine assigned to a dierent
MIDI Channel.
(31) EXT. AUDIO input connects any external line-level audio
source to this 3.5 mm input. If nothing is connected here,
then the main audio output is internally connected to this
external input.
(32) POWER LED lights up to indicate the unit has been
powered on.
(33) MAIN AUDIO uses a 3.5 mm TRS connection to output the
main audio output. Typically it can be patched to the audio
input of another WASP DELUXE or to the audio inputs of
other modular synthesizer equipment. If you are using the
WASP DELUXE in a Eurorack, then this is the main output,
as the rear panel output connectors are not used.
Rear Panel
(34) MAIN OUT uses ¼" TRS outputs to connect to the inputs
of your external equipment as follows (note that they are
both Mono, and not left/right):
•
• LOW - this instrument-level mono output can connect to
the instrument-level inputs of guitar ampliers or
mixers for example.
•
• HIGH - this line-level mono output can connect to the
line-level inputs of mixers, keyboard ampliers, or powered
speakers for example.
(35) MIDI CHANNEL has 4 switches that allow
you to set the MIDI Channel number from 1
to 16 (see the table on page 13). The MIDI channel can
also be changed using MIDI SysEx commands, as shown
in the MIDI SysEx tables later in this manual. (This method
is used when the WASP DELUXE is housed in a Eurorack,
and these switches are no longer present.)
Power Section
(36) POWER switch turns the unit on and o.
(37) DC INPUT connects to the supplied 12V DC power adapter.
tThe power adapter can be plugged into an AC outlet
capable of supplying from 100V to 240V at 50 Hz/60 Hz.
Use only the power adapter supplied.