Behringer X32 - Page 25

25 X32 COMPACT DIGITAL MIXER User Manual
XTEC EQ1
Inspired by the Pultec EQP-1a, this passive equalizer is a very powerful tool for
sound enhancement.
GAIN allows compensation for level changes resulting from frequency
adjustments. Press the 1st encoder to engage or disengage the eect. Select the
low frequency with the LO FREQ knob, adjust the amount of enhancement with
the LO BOOST, then adjust the attack with the LO ATT. The same adjustments are
available for the high frequencies.
XTEC EQ5
This Pultec emulation is a classic analog passive equalizer that oers very warm
and musical frequency sculpting. Simply select the center frequency for the 3
bands, then adjust how much low and high you want to boost and how much
midrange you want to cut.
Sub Octaver
The Sub Octaver provides two channels of sub harmonics generation, one or even
two octaves below the input signal.
Adjust the DIRECT knob to blend the “dry” signal with the lower octaves. Use the
RANGE switch to optimize the tracking by selecting the frequency range of the
input signal. The OCT1 and OCT2 knobs adjust how much 1 octave down and 2
octaves down content is included.
Edison EX1
The EDISON EX1+ is a remarkably eective tool that allows manipulation of the
stereo eld. The eect oers stereo and mid/side input and output and a phase
correlation meter. Exaggerate the stereo eld with the ST SPREAD knob and
adjust the ratio of mono to stereo content with the BALANCE knob. The CENTER
DIST knob allows the mono content to be panned. Compensate for level changes
with the OUTPUT GAIN knob.
Sound Maximizer
Inspired by the Sonic Maximizer 482i, this eect restores natural brilliance and
clarity to any audio signal by adjusting the phase and amplitude integrity to
reveal more of the natural texture of the sound. LO CONTOUR adjusts the level
of phase-corrected low frequencies and PROCESS adjusts the level of phase-
corrected high frequencies. GAIN compensates for level changes caused by
the eect.