To Next PageTo Next Page
Need help?Do you have a question about the Behringer X32 DIGITAL MIXER and is the answer not in the manual?
General| Type | Digital Mixer |
|---|---|
| Channels | 40 |
| Buses | 25 |
| Sample Rate | 48 kHz |
| A/D Resolution | 24-bit |
| Mic Preamps | 32 |
| Effects | 8 x stereo FX slots |
| Inputs | 32 x XLR |
| Outputs | 16 XLR |
| Digital Connectivity | AES50, USB, Ethernet |
| Display | 7" TFT |
| EQ Bands | 4-band Parametric EQ (per channel) |
Critical warnings regarding electric shock risk and opening the unit.
Instructions for safe operation, ventilation, and placement.
Detailed breakdown of the channel strip's sub-sections and functions.
Description of the input channel layers and their selection.
Using faders to control send levels for monitor mixes.
Configuring signal paths for analog and digital outputs.
Setting up processing for Mix Buses and Matrix outputs.
Overview of the X32's eight stereo internal effects engines.
Adjusting preamp gain, phantom power, and phase.
Engaging and adjusting gate and compressor functions.
Adjusting EQ bands, frequency, and bandwidth.
Quickly adjusting bus sends and routing.
Connecting a thumb drive for firmware and recording.
Assigning channels to main bus and adjusting level.
Connecting studio monitors or control room speakers.
Sending audio to external equipment via XLR outputs.
Connecting FireWire/USB and Remote Control devices.
Connecting MIDI and digital AES/EBU audio devices.
Connecting personal monitoring and digital snake systems.
Connecting microphones, line-level sources, and external equipment.
Limiter for distortion-free signal integrity and optimal level.
Three-tap delay for time-based echo effects and stereo separation.
Creates a virtual acoustic space for warmth and depth.
Independent left/right delay times for stereo presence.
Procedures for powering on/off and updating firmware.
Default setup for connecting monitoring and PA systems.
Connecting and processing a microphone signal to the PA.
Applying internal effects as loop or insert styles.
Configuring monitor mixes for live stage performances.
Understanding and using solo bus and monitor sources.
Assigning and controlling channels with mute groups.
Combining and controlling channels using buses and groups.
Configuring AES50 network for signal sharing.
Using matrices for delayed speakers or remote zone mixes.
Connecting and controlling the X32 via network.
Recording stereo mixes directly to a USB drive.
Managing console scenes for different configurations.
Setting up the XUF card within the console's boot cycle.
Installing and configuring the ASIO driver for Windows.
Minimum hardware and recommended operating systems.
Configuring the console as a DAW control surface.
Technical specifications for microphone preamps and inputs.
