Behringer X32 - Page 50

50 X32 COMPACT DIGITAL MIXER User Manual
7.4. 3 Routing Screen: Aux Out Tab
The route screen’s aux out tab allows the user to patch an internal signal
path (such as a mix output used as an eects send) to the 6 separate ¼"/RCA
auxiliaryoutputs.
Since these six outputs can have a wide variety of signal paths assigned to them,
they can be used for a wide variety of tasks, such as:
1. Feeding an external eects processor when the internal eects
areinsucient
2. Patching a specic console signal path into an outboard recorder
3. Feeding the analog or digital audio inputs of a nearby video recorder
To make an assignment as described above, perform the following steps:
4. Adjust the 1st encoder to select which auxiliary outputs to assign a source
for. Choices include:
t Aux Out 1
t Aux Out 2
t Aux Out 3
t Aux Out 4
t Aux Out 5
t Aux Out 6
t AES/EBU (Digital) Out L
t AES/EBU (Digital) Out R
5. Adjust the 3rd encoder to select for coarse range
t Insert
t Main (LRC)
t Mix Bus
t Matrix
t Direct Out
t Monitor
6. Adjust 4th encoder to select specic signal path to feed the selected physical
output. Choices include:
t Insert Point
t Main L
t Main R
t Main C/M
t Any of the 16 Mix Outputs
t Any of the 6 matrix outputs
t Any of the 32 direct outputs
t Any of the 8 Auxiliary Outputs
t Any of the FX Direct Outputs
t Monitor L
t Monitor R
t Talkback
7. Tap the 4th encoder to assign the selected output path,
completingtheprocess.
8. Adjust the 5th encoder to select the signal tap point for the output
assignment. Choices include:
t Input
t Pre-EQ
t Pre-Fader
t Post-Fader
9. Tap the 5th encoder to complete the signal tap point assignment.