EasyManuals Logo

Behringer XENYX 1002 Quick Start Guide

Behringer XENYX 1002
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Quick Start Guide 29
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
Responsible Party Name: MUSIC Tribe Commercial NV Inc.
Address: 5270 Procyon Street
Las Vegas, NV 89118
USA
Phone Number: +1 702 800 8290
XENYX 1202/1002/802/502
complies with the FCC rules as mentioned in the followingparagraph:
This equipment has been tested and found to comply with the limits for a ClassB
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the followingmeasures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician forhelp
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Important information:
Changes or modications to the equipment not expressly approved by MUSIC Tribe
can void the user’s authority to use the equipment.
XENYX 1202/1002/802/502

Other manuals for Behringer XENYX 1002

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Behringer XENYX 1002 and is the answer not in the manual?

Behringer XENYX 1002 Specifications

General IconGeneral
Frequency range10 - 200000 Hz
Channels quantity10 channels
Digital sound processing- bit
Line Signal-to-Noise Ratio (SNR)110 dB
Total Harmonic Distortion (THD)0.005 %
XLR out1
Microphone inYes
DJ mixer-
Product colorBlack
Power consumption (typical)13 W
Weight and Dimensions IconWeight and Dimensions
Depth220 mm
Width189 mm
Height37 mm
Weight1600 g

Related product manuals