Beijer Electronics BoX2 base v2 - Table of Contents

Table of Contents
1. Introduction ................................................................................................ 5
1.1. Note, Tip and Important Icons ................................................................. 5
1.2. Trademarks ........................................................................................ 5
1.3. References ......................................................................................... 6
1.4. Operating Systems ............................................................................... 6
2. General Information ...................................................................................... 7
2.1. Default IP Addresses ............................................................................. 7
2.2. Open Ports ......................................................................................... 7
2.3. LED Indication .................................................................................... 7
3. Configuration .............................................................................................. 9
3.1. How to Set the IP Address in BoX2 ............................................................. 9
4. Image and CODESYS Runtime Update ................................................................. 14
4.1. Update the Image Using USB or SD Card ..................................................... 15
4.2. Update the Image Over Ethernet ............................................................. 16
4.3. Update the Image Version Using Recovery SD Card ........................................ 17
4.4. Update the CODESYS Runtime Version Using USB or SD Card ............................. 18
4.5. Update the CODESYS Runtime Version Over Ethernet ..................................... 19
5. Getting Started and Commonly Used Functions ..................................................... 22
5.1. Create and Download Project Using iX Developer .......................................... 22
5.2. Data Exchange Between Two Controllers .................................................... 24
5.3. Enable Diagnostics Page ........................................................................ 28
5.4. Create a Project in BCS Tools and Download the PLC Program ........................... 30
5.5. Reduce Flash Wear by Storing Data on SD Cards ........................................... 35
Beijer Electronics, MAEN363 3 2023-06