2. General Information
NOTE
BoX2 pro motion is only partly covered in this manual. For more information on
configuring the BoX2 pro motion, see the BoX2 pro motion and BSD Start up manual
(KI00390).
IMPORTANT
When updating the system image through “Make recovery SD card” an SD card
formatted with FAT16/FAT32 and maximum 32 GB must be used.
2.1. Default IP Addresses
These are the default IP addresses for the BoX2 devices:
BoX2 base v2, extreme (incl. SC), pro (incl. SC) BoX2 pro motion
LAN A 192.168.1.1 None (EtherCAT)
LAN B DHCP 192.168.1.1
NOTE
Devices with 2 Ethernet ports MUST NOT have IP addresses in the same subnet.
2.2. Open Ports
In the firmware there are some ports that are open by default due to the operating system or that
the internal application requires it.
Type Description Open by default
UDP and TCP Project transfer (9999) Yes
UDP Netbios (137) Yes
UDP Netbios (138) No
1
1
Filtered.
2.3. LED Indication
BoX2 uses three colors for LED indication; Red, Purple and Blue.
2.3.1. Red
State Description
Constant on Unit is busy booting, or updating image through recovery SD card.
Every 2 seconds
on/off
Unit is in standby/update mode. If image recovery has been run, then
this indicates it has finished, eject SD card and reboot unit.
General Information
Beijer Electronics, MAEN363 7 2023-06
To Next Page
Loading...