Beijer Electronics X2 Series - Setup in IX Developer

X2 control – Basic Start Up settings SUEN284 2017-04
www.beijerelectronics.se 9 (19)
Normal.dotm
, 070221
Setup in iX Developer
iX Developer is used for the HMI application. You are able to design and build the HMI
application in normal for astandard X2 device. iX Developer is completely standalone from
CODESYS and vice versa. Create a new project
Open iX Developer and click on Create New Project.
 Select the iX X2 control device for your system.
 Select SoftControl Direct Access.
Continue to follow the steps to create a new project.
No other communication settings in the SoftControl Direct Access driver needs to be done.